|
SET Asylum Single Ended Triodes (SETs), the ultimate tube lovers dream. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
RE: Dennis talks 2A3... post-RMAF 2016
Posted by dave slagle on December 25, 2016 at 16:54:54:
I think we may be interjecting a bit too much into the accuracy of the sketches. It does appear clear that the anode area is directly related to the filament structure. In the drawings I referenced there are curves around the corner which seems slightly more plausible than the sharp angles shown for the 211. I do strongly suspect that the edges are much more softly defined and and the "boxiness" of the drawings represents the average behavior over an area.
The point I was trying to put forth was that the filament appears to define the "active" plate area and while 100% "anode activity" may be achievable, I am not convinced it is a figure of merit that we should solely base out tube choice decisions on.
dave