OTL Asylum

OTL, Output Transformerless Amplifier User Group.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

It's always the current that matters, whether AC or DC, but..

Posted by Lew on May 7, 2016 at 09:40:11:
AC has a higher propensity to interrupt conduction in the heart muscle, resulting in cardiac arrest. I am guessing that's the basis for the difference in lethality between AC and DC.

Are you saying that it is an intrinsic characteristic of ESLs to present a one-ohm load? I bow to your far superior knowledge, but it does not seem to apply to my Sound Lab 845PXs. I measure impedances in the range of 20-30 ohms, from 50Hz to 2000Hz, about 8 ohms at 5kHz, and reaching as low as 2 ohms only above 10kHz, where the energy demands are minimal. This is using a non-factory full-range audio step-up transformer with a 1:90 turns ratio. (Below about 500Hz, this transformer is in parallel with the Sound Lab bass transformer, which has a much higher turns ratio, probably 1:250, but there are no other passive parts between the amp and the paralleled primaries of the transformers except an inductor in series with the bass transformer.) Since the impedance seen on the primary side will vary as the square of the turns ratio, I concluded that the step-up is a major factor in determining what the amplifier sees and that the intrinsic Z at the panel is much higher. In my view, many modern ESLs are "ruined" for tube amplifiers by added circuitry in front of the step-up audio transformer, such as low value resistances in parallel to effect a crossover, as SL does, all of which tends to bring down Z to values that indeed are very difficult at times for tube amplifiers. (In stock form, Z was around 4-5 ohms at mid-range frequencies for my 845 PXs. There may have been a 2-ohm dip in there too, at 1-2kHz.) With a solid state amplifier, these added circuits do not present much of a problem, but I have yet to meet an SS amplifier that can come close to the musicality of an OTL driving an old school ESL, such as a KLH9 or Quad 57 or my modified Sound Labs.

But I sure do not disagree that direct-drive is Nirvana. I bought my Bev 2SWs just on a lark, to have something to listen to in my basement far from the madding crowd; now I am addicted. Did you sign every Bev DD amplifier? You signed the ones in my 2SWs and dated "1979". Thanks for your contribution to this great speaker.