|
MagneQuest/Peerless Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
Choke for Class A2 211 Grid?
Posted by Triode_Kingdom on October 9, 2016 at 13:28:49:
Mikey, I'm reworking my 211 SETs to clean up a few loose ends. The existing grid chokes aren't gapped, so I've been looking at alternatives. Based on the schematic below, do you think an EXO-01 parafeed choke would work well at L4? This is a lower-Z circuit than most plate loads, so I think 100H is sufficient. Any comments will be appreciated.
Edit: Just to be sure it's clear, the 6BL7 follower has both sections in parallel. I believe the output Z is less than 100 ohms. Total R in the cathode circuit (including the choke's DCR) is approximately 1,600 ohms.