High Efficiency Speaker Asylum

Need speakers that can rock with just one watt? You found da place.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

RE: Electro-Voice Regal lll

Posted by Paul Eizik on January 20, 2017 at 10:17:31:
Craig

The schematic I posted uses 1000 Hz for the low end and 3500 Hz for the high end like the original crossover did, and it's also a 1st order crossover. The parts you link to for C1,C2,L1 and L2 should be fine. I'm not sure how a "stereo L-pad" applies here, as you want a separate mono L-pad on each mid horn and horn tweeter. Dave wanted me to remind you that the L-pads for my schematic should all be 8 Ohm units, and it looks like you are aware of that. You pay more for higher Watt L-pads so budget according to the amp you are using.

16 Ohm speaker drivers were more common in the vacuum tube amp days as tube amps had an efficiency advantage with higher resistance drivers, while transistor amps had an efficiency advantage with lower resistance drivers. The Regal seems to come from that time in the late 60's when the transition from tubes to transistors came about in the market.

Does the schematic make sense? Note that when a wire crosses over another wire, they are not connected to each other at that point unless there is a dot at the cross road. I used the schematic format from one of the calculators we discussed here for the sketch, and I corrected an error where they omitted a dot where the mid minus connects to the amp minus. It's a trivial point but it may have confused someone not used to reading schematics.

Hope all this helps

Paul