|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
RE: Volume Control On PAS-3
Posted by GP49 on June 11, 2009 at 11:46:58:
To disable the loudness function, all you need to do is disconnect everything from the fourth terminal (the one that is not bunched in with the other three) on both the front and rear sections of the volume control. You can just tape off the wires and let them hang, it's not necessary to remove them.
Or you might figure out some other way to use the switch. With minor rewiring it can be configured into a mono switch that will blend the two channels together without any contacts interrupting the signal path; you can then disconnect the factory blend switch, which does interpose several contacts.
GP49