In Reply to: Ultrapath construction question posted by krisgel on March 20, 2003 at 18:40:54:
but realized that the jumpers were not absolutely completely flat against the board (just a hair of an air gap) and that the transformers were not pushed completely down on top of the jumpers (again, just a faint hint of an air gap). It looks like there there is no room for error (!!!) and that when the manual says " . . . as short as possible and flat against the board." and "Make sure that you have them mounted as close to the circuit board as possible." you better make sure that this is done.I had to desolder the transformers and the jumpers but haven't had time to give it another go just yet. I was lucky in that I gave myself just a bit more length on the switch wires or else I would have had the exact same problem with the switches that you have.
I wouldn't mind a helpful hint on this as well.
Follow Ups:
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright Warning! Click for Details ]