Welborne Labs

Posted by krisgel (A) on March 20, 2003 at 18:40:54

I am attemting to install the circuit board and circuit board shelf to the battery cover standoffs. The problem is that the T1 and T2 transformers are about 1/8" to tall. This makes it so that the switches are too short and the battery cover standoffs are too short. The jumper wires below the transformers are as flat against the circuit board as possible. What should I do?

• I think there are two problems here - Ron W 07:55:42 03/21/03 (1)
  • I need the shorter transformers . . . - Jeffm 21:07:54 03/21/03 (0)
• Re: Ultrapath construction question - CE dweeb 07:31:45 03/21/03 (1)
  • Please excuse the double post. - CE dweeb 07:45:33 03/21/03 (0)
• Re: Ultrapath construction question - CE dweeb 07:03:27 03/21/03 (0)
• I had the same problem . . . - Jeffm 19:34:22 03/20/03 (1)
  • The easiest fix - Ron W 08:56:52 03/22/03 (0)

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright Warning! Click for Details ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---