|
Vintage Asylum Classic gear from yesteryear; vintage audio standing the test of time. |
|
|
|
Vintage Asylum Classic gear from yesteryear; vintage audio standing the test of time. |
|
In Reply to: Here we go again . . . Pioneer SX 850 Tech Problem posted by backtobethel on December 30, 2003 at 09:25:37:
The switch relay is dirty, you need to sand the contacts. Very carefully pop the cover off, and using a very fine sandpaper strip or a fine, thin and small file depress the contacts and GENTLY sand them, then release and sand other side across the contact bridge.
Try and use a lint free cloth or can of air to remove any residue left from sanding.If the relay is anything like the one in the sx750 it's a bit of a bitch to get the cover off. If you're not confident, remove the relay from the board before you proceed; it'll be easier that way anyhow.
If this doesn't work there could be myriad other problems, but the symptoms sound like dirty relay contacts.
Good luck and be careful.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Here we go again . . . Pioneer SX 850 Tech Problem - yessir 11:01:48 12/30/03 (2)
- What switch??? - backtobethel 12:45:46 12/30/03 (1)
- Re: What switch??? - yessir 13:07:48 12/30/03 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
