|
Vintage Asylum Classic gear from yesteryear; vintage audio standing the test of time. |
|
|
|
Vintage Asylum Classic gear from yesteryear; vintage audio standing the test of time. |
|
In Reply to: RE: Two Scott 299s to one pair posted by DaveV on January 4, 2017 at 13:38:57:
If you're going to bridge instead of parallel connect, you will need a phase splitter to feed each existing channel signals that are 180-degrees out of phase. A small transformer like the UTC A-18 does a fair job of this, and can run step up or step down.
They will tolerate signal level well below 20 cps at levels quite adequate for the application. Then you hook your 8R speaker between left and right 4R output taps, and ignore the ground.
cheers,
Douglas
Friend, I would not hurt thee for the world...but thou art standing where I am about to shoot.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Two Scott 299s to one pair - PakProtector 07:06:27 01/05/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
