In Reply to: RE: have photo of top of bass? posted by spindoctor on June 6, 2016 at 22:23:16:
Either generate signal with strings or use small signal generator. Follow lines that show AC signal. DC resistance continuity test, for grounding wire scheme.
Should only have two lines going to jack. (+) for signal (center point). And (-) or zero for ground (outside sleeve). Unless, this is a stereo bass going into a stereo amp.
Good luck!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Then, continuity test is in order. - FenderLover 22:58:44 06/06/16 (0)