In Reply to: How to bias this Fisher P/P EL84 amp posted by Awe-d-o-file on June 6, 2015 at 21:19:17:
the posts below are correct. If you want to see how well the tubes are balanced you could install a 1 or 10 ohm cathode resistor on each and then read the bias current directly, calculating using Ohm's law. With the plate voltage (which is probably higher than schematic) you can calculate dissipation and set tubes accordingly. Or just set it to about 33 v as in schematic and if nothing red plates it will be fine...
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: How to bias this Fisher P/P EL84 amp - dls123 06:11:00 06/07/15 (0)