I have the later EL84 model with the tubes aligned along the back edge. I picked up a sams for the amp, however it shows the earlier model with the tubes along the middle perpendicular to the back. I also got a user manual that I was to use for setting bias, etc. The question is that the earlier model has 2-330 ohm 10 watt in parallel resistors into the first cap, my amp did not originally have ANY resistor coming into the first cap, so I installed one 330 10 watt, which is what I have seen in a number of pics online, is that correct? Also, the user manual is for the earlier version which has a different biasing technique, any suggestions on how I should bias this? thanks!
This post is made possible by the generous support of people like you and our sponsors:
Topic - scott 299A question(s)... - gkargreen 12:39:43 11/25/14 (18)
- RE: scott 299A question(s)... - DaveV 15:49:30 11/25/14 (4)
- RE: scott 299A question(s)... - Michael Samra 19:51:48 11/25/14 (2)
- RE: scott 299A question(s)... - DaveV 20:21:54 11/25/14 (1)
- You are the best my friend. - Michael Samra 23:32:39 11/25/14 (0)
- RE: scott 299A question(s)... - gkargreen 18:45:25 11/25/14 (0)
- RE: scott 299A question(s)... - Michael Samra 14:16:04 11/25/14 (12)
- RE: scott 299A question(s)... - gkargreen 15:34:03 11/25/14 (11)
- RE: scott 299A question(s)... - Michael Samra 19:47:06 11/25/14 (10)
- 150 or 180 ohms - gkargreen 08:21:44 11/26/14 (9)
- RE: 150 or 180 ohms - DaveV 10:56:26 11/26/14 (8)
- RE: 150 or 180 ohms - gkargreen 11:33:31 11/26/14 (7)
- RE: 150 or 180 ohms - DaveV 13:30:32 11/26/14 (6)
- RE: 150 or 180 ohms - gkargreen 16:30:31 11/26/14 (5)
- RE: 150 or 180 ohms - DaveV 18:04:40 11/26/14 (4)
- RE: 150 or 180 ohms - gkargreen 21:30:24 11/26/14 (3)
- RE: 150 or 180 ohms - DaveV 22:33:35 11/26/14 (2)
- RE: 150 or 180 ohms - gkargreen 08:27:08 11/27/14 (1)
- RE: 150 or 180 ohms - DaveV 09:32:43 11/27/14 (0)