In Reply to: RE: George Wright AG1000 preamp power transformer spec posted by dls123 on November 2, 2014 at 11:03:11:
Don,
I saw your photo over on Tube DIY. The failed power trafo looks pretty good sized. Maybe you have enough room for 2 off the shelf items to replace that failed part. Mouser stock # 511-L7818CV-DG is a low cost, 1.5 A./18 V., 3 terminal regulator. Antek's AN-0220 toroid, when bridge rectified and filtered, should be adequate to provide for the signal tube heaters. IF the Hammond part I previously mentioned will yield a "tall" enough B+ rail, you might have the makings of a nice repair.
Eli D.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: George Wright AG1000 preamp power transformer spec - Eli Duttman 14:00:05 11/02/14 (1)
- RE: George Wright AG1000 preamp power transformer spec - dls123 14:16:52 11/02/14 (0)