|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: One of the problems with this design posted by Eric Chan on February 11, 2017 at 08:47:58:
Let me give an example to clarify what I was saying. Suppose the driver tube (2nd stage) required a grid bias voltage of -6V at its operating point. As a first approximation this would limit the incoming signal to 6V peak to peak. If we're talking about a diff. pair, as an example let's say that the grids are offset by 3V. Then this condition would cut that 6V envelope in half and incoming signals greater than 3V p-p would distort. This is what I meant when I wrote that it would reduce headroom.
An imbalance in plate currents in the 1st stage diff. amp will result in different plate voltages (depending on the DCR of the plate loads) for the pair. Since the 1st and 2nd stages are direct coupled this difference will be expressed on the grids of the second stage.
If this proves to be the problem you will need to replace the input tube with one that has matched sections as measured in circuit.
"It is better to remain silent and thought a fool, then speak and remove all doubt." A. Lincoln
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: One of the problems with this design - JKT 10:44:28 02/11/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
