|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: You will be fine and I don't even have to measure it and here is why. posted by Michael Samra on September 15, 2016 at 10:37:19:
Dear Friends
Also have the same doubt. My tube amp at startup raises the tension to ~410V for about 20 seconds, then after the tubes start to conduct and lowers to lets say 190V. Do you PPL thing it is safe to use a K75-10 250Volts 50hz/AC here? Some say it´s times 1.4 the tention AC to DC, other say it even can go to times 2.4(???scary).
Tnx
João
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: You will be fine and I don't even have to measure it and here is why. - jonny- 02:14:44 02/10/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
