In Reply to: update posted by vinnie2 on February 8, 2017 at 16:38:53:
The 1 ohm (or similar) surge resistor burned open because of the capacitor. I can see it in the photo, next to the output toroid. This has all been discussed multiple times, I strongly suggest you go back and read the previous posts on using these devices. You need to replace the resistor with a standard 1/2W or 1W approximately 1 to 3 ohms. I also recommend using a smaller cap than 550uF. I've never attempted to power one of these with such a large filter. Again, discussed previously within the last month or so...
Edits: 02/08/17
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: update - Triode_Kingdom 21:28:01 02/08/17 (1)
- RE: update - vinnie2 03:57:36 02/09/17 (0)