In Reply to: RE: Learning how to use psud2 posted by Tre' on February 5, 2017 at 17:58:07:
321.68 volts for the output tubes with less than 1mv ripple peak to peak and 261.64 volts for the drivers at less than 1/10 of 1mv ripple peak to peak.
Edit, I messed up. I entered 50 ohms instead of 60 ohms for the second choke. Both voltages went down by 2 volts, the ripple is the same.
The current tap of 220ma is loaded by right clicking on the filter parts after the spot where you want it and choosing "insert" then "Current tap".
Now right click on the current tap and chose "edit" to change it's value.
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
Edits: 02/05/17
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I assumed 24ma. for the driver stages total. - Tre' 18:08:11 02/05/17 (15)
- How do you expand the graph to show the small increments? - DAK 18:43:57 02/05/17 (6)
- RE: How do you expand the graph to show the small increments? - Tre' 18:47:52 02/05/17 (5)
- RE:when i zoom in the graph goes off screen - DAK 18:55:53 02/05/17 (4)
- RE:when i zoom in the graph goes off screen - Tre' 18:57:17 02/05/17 (3)
- Ok i got to expand just the graph - DAK 19:10:34 02/05/17 (1)
- RE: Ok i got to expand just the graph - Tre' 19:20:42 02/05/17 (0)
- click the zoom buttons until you can see it all then click and drag. - Tre' 19:00:12 02/05/17 (0)
- There is a problem - Tre' 18:37:41 02/05/17 (6)
- RE: if i add ss rectifiers aka Graetz bridge.... - DAK 19:53:09 02/05/17 (4)
- RE: if i add ss rectifiers aka Graetz bridge.... - Tre' 20:07:30 02/05/17 (3)
- RE:what about a 5u4gb ? - DAK 21:21:17 02/05/17 (0)
- RE:what about a 5u4gb ? - DAK 21:12:23 02/05/17 (1)
- RE:what about a 5u4gb ? - Tre' 07:42:18 02/06/17 (0)
- I had to reduce C1 to 3.9uf to get within spec. - Tre' 18:45:53 02/05/17 (0)
- Ok, i am going to input the values and see if i can match u nt. - DAK 18:36:01 02/05/17 (0)