I am just starting to learn the various nuances of correctly inputting the values necessary to get an accurate prediction from psud2 and would appreciate some guidance. I have run a sim with my components but there are a couple of areas where i am unsure of how to proceed.
My power supply is power trans 300-0-300, 28 ohm secondary imp. 5ar4 rectified. filter is 12 uf x 6H 50dcr x 100uf x 6H 60dcr x 100uf. tubes will be 2 x kt120 SE with 6sn7 driver. B+ for the driver will be from RC off the final 100uf cap of 3.3K and 40uf.
I inputted the power supply components up to the 100uf cap and i am not sure about what to input after that. You can choose between a resistive or constant current load. When do you use one or the other? Also should the additional RC section be tacked on the sim to account for the driver tube requirements? Thank you for the help. Dak
Edits: 02/05/17
This post is made possible by the generous support of people like you and our sponsors:
Topic - Learning how to use psud2 - DAK 16:43:59 02/05/17 (20)
- RE: Learning how to use psud2 - Tre' 17:44:43 02/05/17 (19)
- RE: Learning how to use psud2 - DAK 17:54:57 02/05/17 (18)
- RE: Learning how to use psud2 - Tre' 17:58:07 02/05/17 (17)
- RE: 12ma each nt - DAK 18:33:32 02/05/17 (0)
- I assumed 24ma. for the driver stages total. - Tre' 18:08:11 02/05/17 (15)
- How do you expand the graph to show the small increments? - DAK 18:43:57 02/05/17 (6)
- RE: How do you expand the graph to show the small increments? - Tre' 18:47:52 02/05/17 (5)
- RE:when i zoom in the graph goes off screen - DAK 18:55:53 02/05/17 (4)
- RE:when i zoom in the graph goes off screen - Tre' 18:57:17 02/05/17 (3)
- Ok i got to expand just the graph - DAK 19:10:34 02/05/17 (1)
- RE: Ok i got to expand just the graph - Tre' 19:20:42 02/05/17 (0)
- click the zoom buttons until you can see it all then click and drag. - Tre' 19:00:12 02/05/17 (0)
- There is a problem - Tre' 18:37:41 02/05/17 (6)
- RE: if i add ss rectifiers aka Graetz bridge.... - DAK 19:53:09 02/05/17 (4)
- RE: if i add ss rectifiers aka Graetz bridge.... - Tre' 20:07:30 02/05/17 (3)
- RE:what about a 5u4gb ? - DAK 21:21:17 02/05/17 (0)
- RE:what about a 5u4gb ? - DAK 21:12:23 02/05/17 (1)
- RE:what about a 5u4gb ? - Tre' 07:42:18 02/06/17 (0)
- I had to reduce C1 to 3.9uf to get within spec. - Tre' 18:45:53 02/05/17 (0)
- Ok, i am going to input the values and see if i can match u nt. - DAK 18:36:01 02/05/17 (0)