I have a single ended amp (Dennis Had Inspire, single ended 6V6). I wish to use this to power the high frequency section of my Altec two way (414A, 802D). I would like to roll the amp off at 6dB/octave below 6khz or 8khz or so at 6dB/octave.
One option is the simply insert a capacitor inline with the input, but I think I would need to know the input impedance to calculate the value. Another option might be to select a smaller coupling capacitor value to limit LF response.
Any suggestions?
This post is made possible by the generous support of people like you and our sponsors:
Topic - Limiting low frequency response of SE amp - Randal P 06:13:10 02/04/17 (7)
- I assume that this is to feed a tweeter? - Timbo in Oz 18:20:34 02/07/17 (0)
- RE: Limiting low frequency response of SE amp - Paul Joppa 18:23:45 02/04/17 (1)
- RE: Limiting low frequency response of SE amp - dave slagle 11:19:01 02/05/17 (0)
- RE: Limiting low frequency response of SE amp - dave slagle 06:56:41 02/04/17 (0)
- RE: Limiting low frequency response of SE amp - Eli Duttman 06:17:40 02/04/17 (2)
- RE: Limiting low frequency response of SE amp - Randal P 08:27:43 02/04/17 (1)
- RE: Limiting low frequency response of SE amp - Eli Duttman 12:15:34 02/04/17 (0)