|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: what is the purpose of the relay? posted by Eli Duttman on October 26, 2016 at 13:47:49:
Under no circumstances should anyone wire across a protection relay in a solid state amp. The relay does usually eliminate pops at turnon/turnoff, but a more significant function is to de-energize if the protection circuit senses a DC offset at either output channel. That protects the speaker if a power amp channel fails and also hopefully prevents the amplifier from catching on fire.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- It's more than that - Triode_Kingdom 14:08:39 10/26/16 (1)
- RE: Install an aftermarket protection board - deafbykhorns 18:44:36 10/26/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
