|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: THD% estimate a bit too high ... posted by Tre' on October 18, 2016 at 20:39:08:
I doubt it from the measurements DDT posted... distortion cancellation typically results in 2nd and third distortions equalling each other because only the evens "cancel"
when you see a fft of a SE amp that doesn't have the typical dropping in distortion as harmonics go up then you have either a saturating output or driver / output even order cancellation.
dave
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: THD% estimate a bit too high ... - dave slagle 12:59:47 10/19/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]