|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: 3 stage flywheel : mH choke damping resistor posted by Triode_Kingdom on October 19, 2016 at 08:21:15:
"Do you have a hypothesis regarding the increase in energy below 60 Hz?"
At the moment, no. It does run counter to the spice results.
"Is it present without the 1 KHz signal?"
Didn't notice anything unusual.
I ran another overlay where the 220 ohm damping resistor was in place and I compared C2 with 50uF vs. 65uF. The increase in energy below 60Hz didn't appear on that graph.
I'll run the test again when I get home from work to see if this low HZ energy was some sort of bogey or a result I can reproduce.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: 3 stage flywheel : mH choke damping resistor - deathtube 667 08:42:37 10/19/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
