|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Well hello dere 813! posted by 91derlust on October 16, 2016 at 20:19:51:
Sounds like I will be doing a lot of trial and error hunting for the sweet spot. That's always fun anyway I guess.
On a side note, I built my bread boards (one for each channel) on rectangular plywood frames (12"x 24"x 4" roughly) with aluminum top plates and mounted a whole bunch of different type tube sockets, connection terminals and an 125 ese opt on each of them so it is easy to hook up almost any combination. I usually set up the the psu in between them. Oh, and lots and lots of clip leads!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Well hello dere 813! - vinnie2 04:34:43 10/17/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
