In Reply to: balancing the plate volts and plate current posted by vinnie2 on September 28, 2016 at 05:57:32:
Vinnie, can you post your schematic again?
You shouldn't have to change the plate resistor values, just the voltage drop resistor values and the cathode resistor values.
Changing the plate resistor values changes the load line. That changes the design.
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: balancing the plate volts and plate current - Tre' 07:49:32 09/28/16 (14)
- RE: balancing the plate volts and plate current - vinnie2 09:03:30 09/28/16 (13)
- RE: balancing the plate volts and plate current - Tre' 09:57:06 09/28/16 (12)
- Let me try again - Tre' 10:11:58 09/28/16 (11)
- RE: Let me try again - vinnie2 13:56:49 09/28/16 (10)
- RE: Let me try again - Sidewinder 18:12:36 09/28/16 (1)
- RE: Let me try again - vinnie2 18:26:38 09/28/16 (0)
- RE: Let me try again - elblanco 14:48:49 09/28/16 (1)
- RE: Let me try again - vinnie2 15:31:23 09/28/16 (0)
- RE: Let me try again - Tre' 14:45:09 09/28/16 (5)
- RE: Let me try again - vinnie2 15:26:20 09/28/16 (4)
- RE: building the proven/tested circuits ... - deathtube 667 20:02:02 09/28/16 (3)
- RE: building the proven/tested circuits ... - vinnie2 03:41:50 09/29/16 (0)
- RE: building the proven/tested circuits ... - Tre' 20:30:43 09/28/16 (1)
- RE: building the proven/tested circuits ... - vinnie2 03:43:08 09/29/16 (0)