|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: balancing the plate volts and plate current posted by vinnie2 on September 28, 2016 at 05:57:32:
Don't know how close you're trying to get, but don't make yourself crazy striving for exact numbers. Remember that in the golden era, much equipment used resistors and caps with tolerances no better than 10%. Reasonable differences in anode voltage/current usually won't produce markedly different performance.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: balancing the plate volts and plate current - Triode_Kingdom 06:43:49 09/28/16 (1)
- RE: balancing the plate volts and plate current - vinnie2 07:27:40 09/28/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
