In Reply to: RE: Here's one place I like to use WW Mills posted by Triode_Kingdom on September 26, 2016 at 21:38:54:
The OP asked about a "common screen grid resistor, non decoupled, of 750 ohm should be used for G2 for class AB" (assuming PP). This resistor cannot serve as a stopper in the traditional sense due to physical limitations of one resistor serving two tubes. A true stopper app would require separate resistors attached at each g2 socket terminal. The referenced resistor is primarily for voltage drop/isolation and is less critical as to physical construction than that of a true stopper app.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Here's one place I like to use WW Mills - Steve O 08:27:54 09/27/16 (4)
- RE: Here's one place I like to use WW Mills - Triode_Kingdom 12:24:18 09/27/16 (3)
- RE: Here's one place I like to use WW Mills - Steve O 13:00:04 09/27/16 (2)
- But the manufacturer of these specific tubes recommends it - Triode_Kingdom 20:59:17 09/27/16 (0)
- This I agree - FenderLover 14:38:44 09/27/16 (0)