In Reply to: That's not it posted by Triode_Kingdom on September 26, 2016 at 21:35:31:
TK, no they are not. They are tied to PSU past the 10K-ohm dropping resistor. So, the voltage on the screen's voltage is below the anode plates.They tied into the (+) side of the caps (like pi-filter). The caps are grounded on the (-) of each cap. The rail is B+. Not ground.
20-450 = 20/450, in this case. Not (-) ground point.
Edits: 09/26/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Please check schematic, again. - FenderLover 21:41:44 09/26/16 (2)
- Comparing tweed and blackface era setups - FenderLover 22:01:01 09/26/16 (1)
- Only the second schematic has screen resistors - Triode_Kingdom 08:36:07 09/27/16 (0)