|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: IT Transformer connection phasing posted by deafbykhorns on September 16, 2016 at 19:44:36:
Shishido often used the Tango NC10 in anti-phase. The reason was that he felt that the primary and secondary current would somewhat offset, adding to its capacity. The schematic and your 126B drawing are correct and that is how you connect it in circuit. You can try using anti-phase to see if you like it. There is no absolute right answer.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: IT Transformer connection phasing - Chip647 06:27:05 09/17/16 (8)
- RE: IT Transformer connection phasing - andy evans 09:36:04 09/17/16 (7)
- RE: IT Transformer connection phasing - Chip647 14:35:13 09/17/16 (6)
- RE: IT Transformer connection phasing - deafbykhorns 15:26:21 09/17/16 (5)
- Shunt capacitance - Triode_Kingdom 23:57:05 09/17/16 (3)
- RE: Makes perfect sense now - deafbykhorns 10:56:16 09/18/16 (2)
- I connected it wrong at first too.... - andy evans 11:40:28 09/18/16 (1)
- RE: I connected it wrong at first too.... - deafbykhorns 16:20:05 09/18/16 (0)
- RE: IT Transformer connection phasing - Jim Doyle 19:08:12 09/17/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]