In Reply to: RE: SE 6V6 triode : effect of plate to plate feedback ... posted by dave slagle on August 27, 2016 at 09:09:31:
One problem is that the internal sine generator in ARTA is in 1dB steps.
I would need a way to fine tune the signal going into the amp so the output signal over the load resistor can be held with more precision.
Then I could get the same power output and compare THD% when in non-feedback vs. feedback modes.
Or I could use my external signal generator, but that tends to output more distortion than the soundcard.
Thanks for your comment.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: SE 6V6 triode : effect of plate to plate feedback ... - deathtube 667 10:42:55 08/27/16 (1)
- RE: SE 6V6 triode : effect of plate to plate feedback ... - dave slagle 06:36:41 08/28/16 (0)