|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: CCS for 6SN7 driver tube posted by DAK on June 20, 2016 at 17:08:24:
DAK
That link you posted in response to Tre is a SE amp and my understanding is you are building a PP amp with a SE drivers,one to drive the positive half of the cycle and one to drive the negative half of the cycle..Now you said you would one half of each of the 6SN7 driver tubes.I would use one triode of each 6SN7 for voltage gain and the other half as a voltage follower driver.
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
Edits: 06/22/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: CCS for 6SN7 driver tube - Michael Samra 18:43:53 06/21/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
