|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: CCS for 6SN7 driver tube posted by DAK on June 20, 2016 at 12:15:36:
Ok. let me back up a little. I built a very nice sounding "RH KT88" single ended stereo amp which uses a single 6sn7 or 6sl7 to drive the 88. So, instead of make a PSE amp to get more power what if i made it push pull and also get some second harmonic cancellation and maybe that will be an interesting and hopefully very nice sounding amp too. Also, i will get to use some HF87 outputs that had just been door stops, too boot. So my intentions are not to get more power but just to try this amp design. I know there must be some kinks to work out but hopefully not insurmountable ones. I have already made the power supply, which is on a seperate chassis, and about halfway through the amplifier section. So, a concern has been to equalize the gain of each single ended stage. thanx for the help, Dak
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: I sense a lot of head scratching goin on - DAK 17:43:37 06/20/16 (4)
- RE: I sense a lot of head scratching goin on - Tre' 20:37:10 06/20/16 (3)
- RE: I sense a lot of head scratching goin on - DAK 20:46:11 06/20/16 (2)
- RE: I sense a lot of head scratching goin on - Tre' 20:58:21 06/20/16 (1)
- RE: I sense a lot of head scratching goin on - DAK 21:12:25 06/20/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
