|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Tube amp PS - Forgot to add posted by 91derlust on May 4, 2016 at 13:09:39:
Hello 91,
sorry it took so long to get back. Been a little crazy.
Appreciate this. Saw it before when I first investigated the EML tubes, but didn't pay it much attention. I am now.
Clearly, it adds credence to the operating point you suggested. But what really stands out is the suggestion of a battery supply as noted in # 6.
Looking into this very seriously.
On another note to you or anyone else.
When I was playing around with small signal nine pin triodes ( 6922, 6n1p ), types, I used Shunt type gas regs in the PS to great effect. I could easily stack a couple of OD3 and then a RC section to bring it down to where I want to feed the 20B.
Anybody ever use gas regs to feed a DHT such as the 20B.
As always, ANY THOUGHTS are much appreciated.
Cheers, Crazy Bill
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Tube amp PS - Forgot to add - wrm0325 19:36:10 05/07/16 (1)
- RE: Tube amp PS - Forgot to add - 91derlust 20:45:53 05/08/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
