In Reply to: RE: Understanding why... posted by DAK on May 4, 2016 at 13:16:29:
and you want to power the preamp tubes with DC filaments,that would make more sense but I never understood putting DC filaments in any part of an amplifier unless it's for DHTs.
You then have the change in bias over time like Steve mentioned below so that will change the voltage on the filaments as output tubes lose emission over time.
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- If you are talking about an integratd amp - Michael Samra 11:29:06 05/06/16 (1)
- RE: No, its a power amp... - DAK 13:15:21 05/06/16 (0)