|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Need help from Jim McShane posted by musma on April 22, 2016 at 11:33:46:
You can pick up the signals from the phono stage at the Tape Out jacks. When you do that all the controls (volume, balance, tone controls, etc.) are inoperative except the Turnover and Rolloff controls.
Use short, low capacitance cables to connect the Cit I to your pre.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Need help from Jim McShane - Jim McShane 13:30:46 04/22/16 (4)
- RE: Need help from Jim McShane - musma 06:37:31 04/25/16 (2)
- RE: Need help from Jim McShane - Jim McShane 08:20:35 04/25/16 (1)
- RE: Need help from Jim McShane - musma 09:20:01 04/25/16 (0)
- RE: Need help from Jim McShane - Eli Duttman 14:43:16 04/22/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
