|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Filaments and filament bias posted by euro21 on April 15, 2016 at 03:29:02:
Hmmmmm. I thoroughly enjoy my current WCF output stage and I figured since DHTs are so much more linear than the 6as7/6080s I'm using that it simply must sound better. Am I right in assuming this?
In any case I would go for an OTL solution. The filaments complicate it a bit but it won't be too hard to null the offset of the filaments and still get the 1 amp current.
Although I'm still a bit confused on what the cathode to plate voltage is when there are two voltages on either end of the filament.
I'm curious what you meant when you talked about DHT/IDHT mixing and other tubes.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Filaments and filament bias - coin 03:40:56 04/15/16 (2)
- RE: Filaments and filament bias - euro21 03:57:17 04/15/16 (1)
- RE: Filaments and filament bias - coin 05:37:23 04/15/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
