|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Help on oscillation. posted by akltam on February 9, 2016 at 06:52:40:
The resistor should have its body as close to the socket as possible, with the shortest lead length between the resistor body and the pin of the tube as you can get. The 10K would be more effective FWIW.
Also, the ground of the pot and the ground of the cathode resistor should be the same point (which should not be the chassis); from there then use a common wire to the circuit ground.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- That should work, but - Ralph 11:05:50 02/09/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
