|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
I just cannot find a recommendation in the database, my normal source of experience..
I need to replace two 2200uf 350V capacitors in a valve power amplifier. With the cost I must get this right first time. Typically I use Panasonic ED, EE etc in the power supplies but they are much lower voltage.
Is there a manufacturer you prefer in this range. Currently looking at high ripple current options with screw terminals.
This is a class A push pull using 4 EL509s plus 12AU7 and 12BH7 tubes. Current caps mix Panasonic, Elna and Nichicon.
.
must..NOT..resist..."upgraditis"
This post is made possible by the generous support of people like you and our sponsors:
Topic - High Capacitance and voltage capcitors - valvesonly 19:16:18 02/06/16 (10)
- RE: High Capacitance and voltage capcitors - Tweaker456 12:35:23 04/20/16 (0)
- RE: High Capacitance and voltage capcitors - Uncle Mike 06:56:57 02/07/16 (1)
- RE: High Capacitance and voltage capcitors - valvesonly 12:20:56 02/07/16 (0)
- Can you fit a choke and decrease the cap values? (nt) - andy evans 00:50:28 02/07/16 (0)
- RE: High Capacitance and voltage capcitors - Caucasian Blackplate 21:55:05 02/06/16 (2)
- dimensions are - valvesonly 12:13:15 02/07/16 (1)
- RE: dimensions are - Caucasian Blackplate 12:18:07 02/07/16 (0)
- RE: High Capacitance and voltage capcitors - Triode_Kingdom 20:49:21 02/06/16 (1)
- RE: High Capacitance and voltage capcitors - valvesonly 12:15:02 02/07/16 (0)
- RE: High Capacitance and voltage capcitors - Eli Duttman 19:39:03 02/06/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
