|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: round and round we go .......... posted by REL54 on January 23, 2016 at 18:48:23:
As I said, it depends on which parameter you consider the most important. The 1200 ohm resistor is off more than the 1k resistor for plate current, which is almost spot on for the 1k, but the plate voltage is closer with the 1200 ohm resistor. If you subscribe to Jim McShane's explanation of how grid bias should be looked at, the grid voltage becomes a wash. So which is most important, plate current or plate voltage?
Edits: 01/24/16 01/24/16
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: round and round we go .......... - vinnie2 01:43:13 01/24/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
