|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: What he said! posted by tubeflash on November 27, 2015 at 22:12:19:
The transformers I bought are 28V @ 175mA. That's more current than is needed for most bias supplies, but these were available in quantity on eBay at a good price when I was looking. They're small enough to fit under most chassis, they're US-made, and the voltage is about right for many tubes if I use a FW bridge. If more voltage is needed, it's simple to use a doubler as Eli notes below.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: What he said! - Triode_Kingdom 10:03:17 11/28/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
