|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Level 5 2A3 SE Design posted by Tre' on October 29, 2015 at 07:08:36:
Since more gm is needed, and mu of 20 is sufficient there are a few other choices... The 'get a bigger hammer' train of thought comes to mind. Try an HY40....:) Or perhaps an EL84. Rigged as triode, gain is there, and rigged as pentode, the plate load can be quite low, delivering very good drive to the power tube grid.
cheers,
Douglas
Friend, I would not hurt thee for the world...but thou art standing where I am about to shoot.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Level 5 2A3 SE Design - PakProtector 04:00:39 11/12/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
