I have a very early Klimo Kent (El34) amp (from the 80s). At some point some of the diodes were replaced. The remaining original ones are ITT brand, but beyond that all the numbering is worn off. Can I just replace with with IXYS 12A 1000V type diodes with minimal impact on the circuit operating and tube bias points? I have attended to replacing the remaining electrolytic caps as a preventative measure.
I don't have a schematic and am somewhat of a novice when it comes to theory, though I have plenty of experience working on tube gear with schematics.
Any advice or guidance is much appreciated!
This post is made possible by the generous support of people like you and our sponsors:
Topic - diode selection - 8086 22:30:51 11/04/15 (2)
- RE: diode selection UF4007 - Chip647 04:49:23 11/05/15 (1)
- Or UF5408... belt and suspenders sort of guy-nT - Cleantimestream 08:39:37 11/05/15 (0)