In Reply to: Thanks posted by Frihed89 on November 3, 2015 at 09:08:15:
If you are going to use just the large resistors then you need to wire the cathode to the center pole of the switch and run one resistor from the outside pole to ground and again the second resistor on the other outside pole to ground. And don't forget your bypass cap. cheers, Dak
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Thanks - DAK 10:07:42 11/03/15 (3)
- RE: Thanks - Tre' 14:27:54 11/03/15 (2)
- That was my plan nt - Frihed89 10:15:37 11/04/15 (0)
- Yes, yours would be a simpler , easier solution, cheers. nt - DAK 09:49:23 11/04/15 (0)