In Reply to: RE: Level 5 2A3 SE Design posted by larrymoore@ultrafi.biz on October 28, 2015 at 13:32:44:
Of course there is.
Just to list a couple of the other things a driver stage must do.
1. The driver stage has to be able to fully drive the Miler capacitance of the output tube so the output impedance and the drive current need to meet specs.
2. The driver stage should be very linear, after all the output stage is very linear.
I suppose I could go on but what did you have in mind?
Is there something specific, that needs to be done, that a CCS loaded 6sn7 drive stage would not accomplish?
Thanks.
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Level 5 2A3 SE Design - Tre' 14:06:18 10/28/15 (10)
- RE: Level 5 2A3 SE Design - Stuben 12:48:22 10/30/15 (4)
- RE: Level 5 2A3 SE Design - lovetube 16:28:48 10/30/15 (3)
- RE: Level 5 2A3 SE Design - Stuben 09:02:20 11/01/15 (2)
- RE: Level 5 2A3 SE Design - lovetube 16:14:24 11/01/15 (1)
- RE: Level 5 2A3 SE Design - PakProtector 08:53:39 11/12/15 (0)
- RE: Level 5 2A3 SE Design - larrymoore@ultrafi.biz 14:33:32 10/28/15 (4)
- RE: Level 5 2A3 SE Design - Tre' 15:12:48 10/28/15 (3)
- RE: Level 5 2A3 SE Design - larrymoore@ultrafi.biz 05:13:20 10/29/15 (2)
- RE: Level 5 2A3 SE Design - Tre' 07:08:36 10/29/15 (1)
- RE: Level 5 2A3 SE Design - PakProtector 04:00:39 11/12/15 (0)