|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Choke Filter for power supply posted by onthethreshold1 on August 28, 2015 at 16:20:57:
A CLC or Pi filter is like the above schematic.
You need a cap before and after the choke.
First one so that the B+ stays about the same.
Second is to make the PS a voltage source.
If you post me off-board I can take you through it.
I will also need to model it in PSUD
to get the "right" choke for your amp.
DanL
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Choke Filter for power supply - danlaudionut 16:52:41 08/28/15 (6)
- RE: Choke Filter for power supply - Garg0yle 19:45:26 08/28/15 (5)
- Serious Hoakum - Triode_Kingdom 23:48:40 08/28/15 (2)
- RE: One you might want to look at - Russ57 10:50:52 08/29/15 (1)
- RE: One you might want to look at - Eli Duttman 12:19:09 08/29/15 (0)
- RE: Choke Filter for power supply - danlaudionut 19:57:18 08/28/15 (1)
- RE: Choke Filter for power supply - Garg0yle 20:32:57 08/28/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
