RE: Keysight/Agilent U1241B - amp output noise measurement

"To measure low AC voltage, the signal must overcome the internal rectifier's forward voltage"

Paul, are you sure modern meters use a rectifier? I had just assumed an ADC would be used for this, with the lowest measurable signal equal to one bit. Of course, I haven't studied AC measurement techniques relating to instruments in years. :)

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Keysight/Agilent U1241B - amp output noise measurement - 91derlust 03:36:43 08/26/15 (13)

RE: At least they are honest - Russ57 15:50:51 08/27/15 (3)

I think they are, but it is still unclear. - 91derlust 18:28:51 08/28/15 (2)

RE: I think they are, but it is still unclear. - Garg0yle 19:04:18 08/28/15 (1)

RE: I think they are, but it is still unclear. - 91derlust 13:58:41 08/29/15 (0)

RE: Keysight/Agilent U1241B - amp output noise measurement - 91derlust 00:27:24 08/27/15 (3)

Keysight/Agilent U1241B - Brochure states 0.1 mV to 1000 V - 91derlust 00:52:01 08/27/15 (2)

RE: Keysight/Agilent U1241B - Brochure states 0.1 mV to 1000 V - Garg0yle 09:10:50 08/27/15 (1)

RE: Keysight/Agilent U1241B - Brochure states 0.1 mV to 1000 V - 91derlust 18:22:13 08/28/15 (0)

RE: Keysight/Agilent U1241B - amp output noise measurement - Paul Joppa 17:04:04 08/26/15 (1)

RE: Keysight/Agilent U1241B - amp output noise measurement - Triode_Kingdom 12:57:18 08/27/15 (0)

RE: Keysight/Agilent U1241B - amp output noise measurement - Caucasian Blackplate 14:36:49 08/26/15 (0)

RE: Keysight/Agilent U1241B - amp output noise measurement - Chip647 11:12:43 08/26/15 (0)

RE: Keysight/Agilent U1241B - amp output noise measurement - Triode_Kingdom 11:01:12 08/26/15 (0)

Follow Ups

RE: Keysight/Agilent U1241B - amp output noise measurement - Triode_Kingdom 12:57:18 08/27/15 (0)

RE: Keysight/Agilent U1241B - amp output noise measurement

Post a Message!