In Reply to: confused I am... posted by vinnie2 on August 17, 2015 at 07:31:43:
>> so that one is plate to either of the filament ends correct?
Correct
>> plate current and grid volts I am not sure how to measure.
The voltage across the cathode resistor is your bias voltage.
Divide that voltage by 850 (cathode resistor)
and you get the plate current.
Ohms Law (Versions of same equation)
V = I*R
I = V/R
R = V/I
School's Out 8^D
DanL
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: confused I am... - danlaudionut 07:56:56 08/17/15 (7)
- RE: confused I am... - Lew 11:18:22 08/17/15 (3)
- RE: confused I am... - vinnie2 13:14:07 08/17/15 (2)
- RE: confused I am... - Tre' 14:03:11 08/17/15 (1)
- RE: confused I am... - vinnie2 14:33:32 08/17/15 (0)
- RE: confused I am... - vinnie2 09:38:46 08/17/15 (2)
- RE: confused I am... - danlaudionut 11:21:10 08/17/15 (1)
- RE: confused I am... - vinnie2 13:11:22 08/17/15 (0)