In Reply to: 211 valve bias question posted by 2395 on July 6, 2015 at 20:05:20:
Thanks everyone so far
Palustris.......thanks for your input
my intention is to put a switch in to switch in/out [while of] between an analogue amp meter [100ma] in circuit for bias adjust when tube rolling etc.
thus the question of where to put....before, over or after the resistor and what will be the differences in the readings
I will implement your resistor and pot network when doing the meter input......and thanks re the simulator.....does not appear to have the 211 valveTriode King......thanks for your input.....
amps are VAL MP-211 [mono blocks] based upon an original Kondo design.....can provide schematic [via email] for your perusal and opinion .......Chips647......thanks for your input.....
Tre'.....thanks for your input.....
your volt meter is good ......I was thinking in line of an amp-meter and wether to put it before, after or across the resistor and what the difference would be in the current readingsagain thanks all so far ....looking forward to more info
Edits: 07/07/15
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Thanks everyone so far ........??.... - 2395 22:59:46 07/07/15 (1)
- RE: Thanks everyone so far ........??.... - Tre' 11:10:14 07/08/15 (0)