|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Did you pull one leg of the resistor before measuring them? (n/t) posted by FenderLover on July 3, 2015 at 18:14:20:
No, I didn't. The bad resistor was open, but after installing the new 210k resistor, both channel's plate resistor measure the same-about 210k ohms. I've been playing music through this amp for about 3 hours now and everything seems to be fine. So, should I leave it as is or change the resistors to 100k as indicated in the color code and schematic?
David
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Did you pull one leg of the resistor before measuring them? (n/t) - Sidewinder 19:21:14 07/03/15 (3)
- grid-leak resistor - FenderLover 00:57:04 07/04/15 (2)
- RE: grid-leak resistor - Sidewinder 01:26:49 07/04/15 (1)
- fuses - FenderLover 07:45:33 07/04/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
