In Reply to: RE: Here's a Guy Doing Something Similar posted by LinuxGuru on June 22, 2015 at 08:59:13:
"this device is far from optimal because of vast amount copper-clean space required between pads."
Yes, that's a good point. It does need more margin for HV applications. Maybe I'll try cutting patterns with an end mill. If I can keep the board flat during the process, that might work OK. Or, as Adam suggested, maybe it's just best in the long run to have them made. Some of my upcoming designs will use ICs for monitoring and bias control. Those definitely need a commercial approach. BTW, this is for final use. I have high quality through-plated proto boards for solid-state prototyping.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Here's a Guy Doing Something Similar - Triode_Kingdom 09:21:27 06/22/15 (2)
- RE: Here's a Guy Doing Something Similar - dave slagle 12:52:14 06/22/15 (0)
- RE: Here's a Guy Doing Something Similar - LinuxGuru 10:01:44 06/22/15 (0)