|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Schottky diodes posted by Caucasian Blackplate on June 9, 2015 at 08:19:06:
"What will you do if the Schottky bridge makes too much voltage?"
Increase the single 1R resistor after the diode bridge.
Conversely, if there was too low a voltage would it be possible to drop the value of the the two before the bridge say to 0.1R? What is the purpose of these two and how low could one safely go?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Schottky diodes - mashley 22:07:28 06/09/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
